Maintenance welding on industrial frames is rarely done in ideal conditions. You may be repairing a cracked bracket in a plant, rebuilding a machine base outdoors, or adding reinforcement to…
Steel brackets are a good test for a stick welder. The joints are often short, but bracket plate can be thick enough to demand real arc power, and 6011 electrodes…
What matters for tack-welding structural assemblies For fitting up beams, columns, brackets, and frames, a stick welder needs to do more than strike an arc once. It should start reliably…
Why stick welding suits dump-body repairs Cracked dump bodies are awkward repair jobs: the steel may be thick, dirty, outdoors, and exposed to wind. Stick welding is a practical choice…
Small aluminum parts expose every weakness in a TIG welder. Thin sheet, brackets, housings, and tubing have little thermal mass, so a few seconds of excess heat can cause burn-through…
A steel workbench is a demanding but manageable stick-welding project. Its long seams and heavy parts reward a machine with a steady arc and enough output for 1/8-inch electrodes; they…
Thin titanium sheet is unforgiving, but the welder is rarely the only problem. You need stable DC TIG output, a clean gas system, reliable high-frequency starting, and enough shielding to…
Choosing a stick welder for a remote fence job For steel fence posts far from a shop, the right stick welder is usually a portable inverter that can run from…
Repairing a loader bucket is not just a matter of sticking a patch over thin steel. The cutting edge, floor and side plates see impact, abrasion and dirt contamination, and…
Choosing a TIG Welder for Copper Bus Bars Copper is weldable with TIG, but it is much less forgiving than mild steel or stainless. Its thermal conductivity pulls heat away…