How to Test an Auto-Darkening Welding Helmet Before Work
An auto-darkening welding helmet should be tested before every work session, not just when it comes out of the box.
1795 articles published
An auto-darkening welding helmet should be tested before every work session, not just when it comes out of the box.
A plasma cutter needs a complete electrical circuit to cut cleanly. The torch creates an arc, but the current must return through the workpiece and work…
Auto-darkening helmets do not all react to the same arc equally. A setting that works for a 180-amp MIG weld may be too insensitive for a low-amp TIG job…
Plasma dross is the hardened metal left along the bottom edge of a plasma-cut part.
Plasma cutting can produce clean parts quickly, but poor layout planning wastes more metal than the cutting itself.
A plasma cutter can make a fast, clean weld-preparation bevel, but it will not automatically produce the same consistent angle as a milling machine or…
A plasma cutter produces an electric arc and a stream of molten metal that can travel several feet.
Plasma consumables are wear parts. The electrode, nozzle, swirl ring, shield, and retaining cap eventually need replacement, but poor setup can destroy…
Plasma air pressure is not a universal setting. The correct number depends on the cutter, torch, consumable set, material thickness, and whether you are…
Choosing an air compressor for plasma cutting is mainly a matter of matching airflow, pressure, and duty cycle to the cutter—not simply buying the largest…